Gauge:
4.5 stitches per inch
5.5 rows per inch
Stitch Explanation:
K—knit
P—purl
st(s)—stitch(es)
St st—stockinette stitch
arnd—around
rnd—round
K2tog—knit two together
Notes:
This pattern is for a plain hat with the Bevo logo made out of white felt and attached later. I tried to design a logo for Bevo, but I couldn't make it small enough to fit on the hat and still look good, thusly the felt.
Pattern:
Cast on 110 sts. (Increase or decrease the number of sts in multiples of 10 for a larger or smaller hat. Alternatively, you could use a smaller or larger needle size.) Join, being careful not to twist work. Place marker to indicate end of round.
Work in K1P1 rib for 3 inches.
Switch to St st and work even for 7 inches. Begin decreases.
Decreases:
(Change to double pointed needles as needed.)
Rnd 1: (K8, K2tog) around—99 sts.
Rnd 2 and all even rows: K around.
Rnd 3: (K7, K2tog)around—88 sts.
Rnd 5: (K6, K2tog) around—77 sts.
Rnd 7: (K5, K2tog) around—66 sts.
Rnd 9: (K4, K2tog) around—55 sts.
Rnd 11: (K3, K2tog) around—44 sts.
Rnd 13: (K2, K2tog) around—33 sts.
Rnd 15: (K1, K2tog) around—22 sts.
Rnd 17: (K2tog) around—11 sts.
Cut off long end of yarn and thread it through remaining 11 sts and pull tight.
Make Bevo logo:
Print out the following diagram and use it as the pattern on the piece of white felt for Bevo. Cut out the white felt according to the pattern and glue it to the hat, about an inch up from the end of the ribbing. You may wish to cut two thicknesses if your felt is a little transparent.
Block; weave in all ends.
|
